Siemens SIMATIC NET RUGGEDCOM MX5000RE Equipment Manual page 59

Device Management
4.4 Accessing the CompactFlash Card
Configuration hazard – risk of data corruption/loss
The following will void the warranty and potentially result in configuration data
corruption/loss:
•
•
Inserting the CF card
To insert the CF card into the device, do the following:
The device should only be powered on when the CF card is present.
1.
2.
3.
4.
Removing the CF card
To remove the CF card from the device, do the following:
1.
50
NOTICE
Using a CF card not approved by Siemens for use with this device
Removing the CF card in any scenario other than those described in this section
NOTICE
Make sure the device is powered down.
Remove the CF card access panel.
Insert the CF card into the slot until it is fully seated.
1
2
CompactFlash Card
1
Access Panel
2
Figure 4.3 Inserting the CF Card
Secure the CF card access panel to the chassis.
Make sure the device is powered down.
RUGGEDCOM MX5000RE
Equipment Manual, 11/2023, C79000-G8976-1060-17