Table of Contents
Advertisement
26
When
using
a one-pin
plug
microphone
such
as
the
Sony
Electret Condenser Microphone
ECM-250D
(optional),
only the
MIC jack is used.
Other recording procedures are the same as those
used when
recording with the built-in MICROPHONE.
To monitor while recording
Plug the supplied earphone into the MONITOR
jack.
Setting the MONITOR
selector at SOURCE,
source sounds
can
be monitored,
and at the TAPE position the just-recorded sounds
can be monitored, through the earphone.
Thus you can see that the TC-142 is surely recording by setting
the MONITOR
selector to the TAPE
position.
END ALARM
system
|
The END ALARM
lamp will start to flicker a few minutes before
end-of-tape in the record
mode.
Simultaneously,
an
alarm
is
heard through the earphone.
With the Sony Cassette Tape C-30 and C-60, the lamp will begin
to flicker about 1.5 minutes before end-of-tape, with C-90 about
2.5 minutes and with C-120 about 3.5 minutes before
end-of-
tape.
Tape Counter
|
Use the Tape Counter for indexing tape contents.
Before record-
ing, set the Tape Counter to "O0QQ" by pushing the Reset Button.
The figures on the counter change as the tape passes.
Make
a note of the figures and the program being recorded.
Advertisement
Table of Contents
