Assembly - Maxxus RunMAXX 3.0 Installation & Operating Manual

Assembly

Carefully unpack all delivered parts. Have someone there to help you as some of the training device parts are
bulky and heavy.
Check that all the parts and xing materials (screws, nuts, etc.) have been delivered.
Assemble the parts carefully as any damages or defects occurring due to mistakes made at the time of assem-
bly are not covered by the warranty or guarantee. Therefore, read through the assembly instructions carefully
before you start assembling, follow each assembly step exactly as described and keep to the correct sequence
of assembly as instructed. Assembly of the training device must be carried out thoroughly by adults only.
Assemble the training device in a location which is level, clean and clear of obstructions. 2 people are required
to carry out the assembly. Training can only start when the training device has been fully assembled.
Step 1: Preparing for Assembly
Remove all treadmill parts rom the packaging. Place the base rame on a clean at surace.
Step 2 Assembling the Side Frames & Cockpit Frame
Lift the two side frames and secure them to each side of the base frame from the outside with a hexagon socket
screw M8x35. Then rmly tighten the pre-assembled hexagon socket screws located just below the screws
previously tted.
Lit the cockpit rame upwards and x it rom the inside to each side o the side rame using an M8x12 hexagon
socket screw. Then tighten the preassembled hexagon socket screws located just below the other two screws
you have just tted. ENG
CAUTION: Make sure that the cable in the right side-rame does not get damaged or jammed whilst you are
assembling the cockpit frame.
5