HBM SomatXR CX23-R Quick Start Manual page 2

CX23-R Quick Start Guide
In the Box
CX23-R unit with dust caps 1-KAB2106-2 Ethernet cable
o o
1-KAB2115-2 power cable USB flash drive
o o
CX23-R Data Controller
CX23-R Status LEDs
SYNC (blue) POWER (green)
On Sample clock is synchronized Off
to PTP source.
On
4 Hz Sample clock is synchronized
4 Hz
to GPS source.
2 Hz
1 Hz Sample clock is not externally
regulated.
SomatXR Safety Manual
o
CX23-R Quick Start Guide
o
RUN (yellow)
Unit is off. Off No test run is in progress.
Unit is on. 4 Hz Test run is in progress.
Unit is shutting down.
ERROR (red)
Unit is in locate mode.
Off No error.
On Unit error.
1 Hz User alert.
Setting up the CX23-R
1. Connect the 1-KAB2115 power cable from the INPUT connector to a
10-30 V power source. Alternatively, use the 1-NTX003 power supply.
DC
NOTE
The green wire of the 1-KAB2115 cable must be insulated or tied to +V
2. Connect the 1-KAB2106 Ethernet cable from the HOST connector to the
host PC. The host PC network settings must be compatible with the
CX23-R default IP address 192.168.100.101.
3. Connect desired transducers to DIO, GPS, AUX and CAN ports using the
appropriate sensor cables. Refer to the SomatXR Accessories Data Sheet
for a complete list of sensor cables.
CX23-R Quick Start Guide
4. Wait at least five seconds after
supplying power to the unit.
5. Press and release the power
button. The green and blue LEDs
.
DC
turn on. Wait about 15 seconds for
the unit to boot up.
6. Open a web browser and navigate
to the default IP address
192.168.100.101. If presented with
a certificate warning, choose to
proceed. The CX23-R web
interface is displayed.