Using A Power Supply Adapter - Enterasys WS-AP3765i Installation Manual

Connecting the Cables
To fit and connect a power supply adapter:
1. Fit the power supply adapter in the access point, as depicted in
the rear of the power supply adapter must engage fully in the socket of the housing. The entire
rear surface of the power supply adapter must make contact with the inner surface of the
access point.
Figure 3-3
2. Connect the power supply adapter and the AP with the screw supplied with the power
supply adapter (position A in
3. Connect the cable from the power supply. The assignment of the contacts is depicted in
Figure
4. Secure the power supply cable with a strain relief clamp. See
Cable
3-8 Connecting Cables to the Outdoor Access Points
Note: The Enterasys 100-240V AC power supply adapter (WS-PS376X-MR) is identical to the
Siemens PS791-2AC power supply adapter, and is shipped with that part number on the label.
Warning: Power supply cables may be connected only when the power is turned off. Start up the
AP only after screwing the housing cover in place again so that protection from touching live parts is
restored.
Note: The WS-AP3765 and WS-AP3767e are shipped with a 24V DC cable connector installed in
the socket. If you are going to use a 100-240V AC power supply, remove the DC cable connector
from the power socket and install the power supply adapter as described below.

Using a Power Supply Adapter

Caution: Use the loop (Position B in
This prevents the connector skewing on the back of the power supply adapter and breaking off.
3-3.
Connections" on page 3-12 for more information.
Figure 3-3) to remove the power supply adapter from the AP.
Figure 3-3).
Figure 3-3. The connector on
"Using Strain Relief Clamps on