Fitting A Power Supply Adapter; Position Of The Opening In The Housing For The Power Supply With The Housing Cover Removed; Position Of The Connector When Inserted In The Socket Of The Housing - Enterasys AP2650 Installation Manual

Figure 3-3
Cover Removed
When connecting the cores, you should therefore make sure that the connector is oriented as
depicted in Figure
Figure 3-4
2. Press the connector into the socket in the housing until it engages.
3. Secure the power cable with a strain relief clamp.

Fitting a Power Supply Adapter

The Enterasys Wireless Outdoor AP supports only the 110‐230 V AC power supply adapter.
To fit and connect a power supply adapter:
1. Fit the power supply adapter in the Enterasys Wireless Outdoor AP, as depicted in Figure
The connector on the rear of the power supply adapter must engage fully in the socket of the
housing. The entire rear surface of the power supply adapter must make contact with the
inner surface of the Enterasys Wireless Outdoor AP.
Position of the Opening in the Housing for the Power Supply with the Housing
3‐4.

Position of the Connector When Inserted in the Socket of the Housing

Warning: Power supply cables may only be connected when the power is turned off. Start up the
Enterasys Wireless Outdoor AP only after screwing the housing cover in place again so that
protection from touching live parts is restored.
Fitting a Power Supply Adapter
Enterasys Wireless Outdoor AP Installation Guide 3-7
3‐5.