Figure 1-3
WS-AP3767e LEDs
Table 1-4 WS-AP3767e LED Descriptions
LED
L1
P1
P2
R1
R2
F
Reset Button
The reset button is located below the housing cover beside the sockets for external antennas as
depicted in
button.
Color
Meaning
Green
Power LED. When on, indicates AP power is sourced from power supply.
Green
SFP port 1 LED.
When green on, indicates SFP port activity.
When off, port is off, WDS is enabled.
Green
SFP port 2 LED.
When green on, indicates SFP port activity.
When off, port is off, WDS is enabled.
Green
WLAN Radio 1 LED.
When green on, indicates Radio 1 is active.
Amber
When amber on, indicates WDS up link.
Green
WLAN Radio 2 LED.
When green on, indicates Radio 2 is active.
Red
Error LED.
When on, indicates error.
When off, indicates normal operation, AP connected to controller.
Figure 1-4
on page 1-6. You must remove the housing cover to gain access to the reset
Warning: Turn off the power supply of the access point before you remove the housing cover. After
you have removed the housing cover, turn the power on to use the reset button.
Enterasys Wireless Outdoor Access Points Installation Guide 1-5
Reset Button