Connecting A Cable And Fitting The Strain Relief Clamps; Securing A Sealing Plug With A Strain Relief Clamp - Enterasys WS-AP3765i Installation Manual

Figure 3-7

Connecting a Cable and Fitting the Strain Relief Clamps

B
1. Connect cables with a pre-assembled connector (Ethernet, antennas) by inserting the
connector into the appropriate socket. Secure antenna cables by tightening the sleeve nut of
the connector (key size SW8).
2. Fit a strain relief clamp to the connected cable. The toothed part of the clamp must enclose the
cable completely (is depicted by Position B
3. Press the strain relief clamp into the housing until the cable is located completely in the
opening in the housing seal (Position C in
4. Seal all openings not required for cables with sealing plugs (Position D in
5. Fit these sealing plugs in a strain relief clamp. The lower surrounding notch must be enclosed
by the strain relief clamp (as depicted in
housing until the sealing plug is located completely in the opening of the housing seal.
Figure 3-8

Securing a Sealing Plug with a Strain Relief Clamp

Note: Keep unused sealing plugs and strain relief clamps for later use.
A
D
C
Figure 3-7).
Figure 3-7).
Figure 3-8). Press the strain relief clamp into the
Enterasys Wireless Outdoor Access Points Installation Guide 3-13
Connecting the Cables
Figure 3-7).