Table of Contents
Advertisement
Mounting with Mounting Bracket
2.
Secure the AP to the wall with three screws (Position B
supplied with the device. The type and length of the screws depend on the type of wall.
Option: Threaded Holes on Rear of Housing
When a wall is extremely thin, it is often not possible to use wall plugs for the screws. To allow
wall mounting in this situation, four M4 threaded holes are provided on the rear of the
WS-AP3765. The drilling template is a square with sides 100 mm long. The device can therefore be
mounted on a wall with bolts through the wall.
Mounting with Mounting Bracket
The mounting bracket (WS-MB376X-01) is optional and can be ordered separately. See
page 1-3.
Regarding Installation Location
•
Devices with an internal antenna must be aligned according to the characteristics of the
internal antenna (refer to the technical specifications of the antenna
page 4-4 and Radiation pattern diagrams
Since the internal antennas are integrated in the housing, the location and alignment of the
housing decides the radiation direction of the antennas.
•
There are no restrictions relating to devices without internal antennas.
Fitting the Mounting Bracket to a Wall
The locations of the holes for fitting the mounting bracket to a wall are depicted in
Measurements are in centimeters.
Figure 2-6
2-6 Mounting the Outdoor Access Point
Drilling Template for Fitting the Mounting Bracket to a Wall
Figure
2-5). The screws are not
"Internal Antenna Radiation
Table 1-1
on
"External
Antennas" on
Patterns" on page 4-5).
Figure
2-6.
Advertisement
Table of Contents
