Reset Switch; Kensington Lock Slot - Enterasys WS-AP3705i Installation Manual

The WS-AP3705i appears as an Ethernet node and performs a bridging function by moving
packets from the wired LAN to remote workstations on the wireless infrastructure.
The LAN port also supports power over Ethernet (PoE) based on the IEEE 802.3at standard. Refer
to "Power
network port from a network device, such as a switch, that provides Power over Ethernet (PoE).

Reset Switch

The WS-AP3705i provides a Reset Switch to reset or restore factory default configurations. Use a
pen tip or a nail to press the switch button through the hole (located on the side of the AP). If you
hold down the button for less than 5 seconds, the WS-AP3705i performs a software interrupt,
causing the AP to drop all connections and reset. If you hold the button down for 5 seconds or
more, any configuration changes are removed, and the factory default configuration restores to
the WS-AP3705i.

Kensington Lock Slot

There is a slot for a Kensington lock through the mounting bracket locking tab and the side of the
AP, above the rivet
on use of the lock.
1-4 WS-AP3705i Overview
Connections" on page 2-9, for information on supplying power to the WS-AP3705i
(Figure 1-2 on page 1-3). See Kensington lock documentation for instructions
Draft