Servicing - Removal And Replacement; External Covers - Mackworth TX440 Advanced PT Service Manual

9.0 Servicing – Removal and Replacement
This section will cover the details of how to remove, refit and replace all serviceable parts to the
Hoist. The step by step process is to be followed in sequence to perform a successful service on the
Hoist. Unless stated otherwise, all images refer to a Mackworth TX600 Advanced with a Standard
Wheel Assembly (Track Type 1). Where necessary, additional images for Alternative Track Types
have been included.
NOTE: Before carrying out any work on a TX Hoist, remember to switch off the power first. This
action can be carried out by pulling on the E-Lower cord once.
When Servicing the TX Hoist, a work bench or table should be used, along with a protective cover
such as a cloth to avoid damaging the Hoist. The TX Service Stand is highly recommended to assist
during servicing. See image below of the Service Stand.

External Covers

This section will instruct the correct procedure on how to remove and replace the External
Covers.
Removal
Step 1 – Using a Pozi Screwdriver, loosen the four screws (Arrowed), the screws do not need
to be removed.
Page 24 of 63