Wheels - Mackworth TX440 Advanced PT Service Manual

C) When winding the lift tape back around the hub make sure to rotate the hub in a
clockwise direction while looking at the Hoist in the direction shown in the image
below.
D) Use long noise pliers to reattach the 8mm E-Clip to the end of the strap pin.

Wheels

This section will explain the correct procedure on removing and reinstalling all wheel variants used
with the Ceiling Track Hoist
9.11.1 Wheels (excluding QRT Variants)
Within this section it will explain the correct procedure on removing and reinstalling all wheel
variants of the Hoist (excluding the QRT System Hoist), this section will include Track Type 1, 2,3,4,5.
See Section 1 for guidance on the track type profiles.
The images below refer to the Standard Wheel (Track Type 1), but the same procedure will apply
to all the Wheel variants.
Removal
Step 1 – Using circlip pliers, remove the circlips from both wheels. (arrowed)
Step 2 – Remove the two Wheels from the Hoist as shown – Ensure the Spacers are situated
within the Wheels.
Page 42 of 63