Charging Beak
Within this section it will explain the correct procedure on removing and reinstalling all Charging
Dock variants, Including Track Type 1, 2,3,4,5. See section 1 for guidance on the track type profiles.
9.12.1 Charging Beak – Standard (Track Type 1)
Within this section it will explain the correct procedure on removing and reinstalling the
Charging Beak for servicing procedures or replacement.
Removal
Step 1 - Remove external covers off the Hoist. (refer to section 9.1)
Step 2 – Remove the Battery from the battery brackets. (refer to section (9.3)
Step 3 – Disconnect the Charging Beak from the PCB.
Step 4 – Reroute the Wire from under the Battery Bracket.
Step 5 – Cut all three Cable Tie's that secure the wire to the Chassis.
Step 6 – Using a 2mm Allen Key, Remove the M3x12 Screws and M3 Nyloc Nuts to release
the Charging Beak.
Page 45 of 63