Toggle Switch - Mackworth TX440 Advanced PT Service Manual

Step 8 - Refitting is a reversal of the removal process noting the following point:
A) Ensure that when repositioning the Air Grommet, it is in the correct orientation as
shown below
B) Once the Air Tubes have been refitted, make sure to have pulled the tubes all the way
through the Chassis. They should not be left slack inside the Chassis.

Toggle switch

This section will instruct the correct procedure on how to remove and replace the Toggle
Switch.
Removal
Step 1 - Remove external covers off the Hoist. (refer to section 9.1)
Step 2 – Remove the Battery from the battery brackets. (refer to section (9.3)
Step 3 – Remove QRS Hook. (Refer to section 9.6)
Step 4 – Remove Bottom cover from Hoist. (Refer to section 9.7)
Step 5 – Remove the E-Lower Cord. (Refer to section 9.17)
Step 6 – Disconnect the Toggle Switch from the PCB.
Step 7 – Disconnect the Motor wires from the Toggle Switch
Page 56 of 63