Lift Tape - Mackworth TX440 Advanced PT Service Manual

Lift Tape

This section will instruct the correct procedure on how to remove and replace the Lift Tape.
Removal
Step 1 - Remove external covers from the Hoist. (refer to section 9.1)
Step 2 – Remove the PCB from the Hoist. (refer to section 9.2)
Step 3 – Remove the Battery from the battery brackets. (refer to section (9.3)
Step 4 – Remove QRS Hook. (Refer to section 9.6)
Step 5 – Remove Bottom Cover from Hoist. (Refer to section 9.7)
Step 6 – Remove Lift Motor from Hoist. (Refer to section 9.5)
Step 7 – Pull the lift tape until it have fully unwound from the Hub.
Step 8 - Using a small slotted screwdriver remove the 8mm E-clip from the Strap pin.
Page 40 of 63