Advertisement
Connecting the Battery
1. Assemble the positive-battery cable into the positive
stud of the battery
(3/8 inch) that you removed in step
the Battery (page
1).
2. Torque the lock-washer nut to (10 to 15 ft-lb) and align
the insulator boot over the nut and stud.
3. Assemble the negative-battery cable into the negative
stud of the battery
(3/8 inch) that you removed in step
the Battery (page
1).
4. Align the holes in the battery cover with the clip nuts
at the mounting flange for the cover
5. Secure the battery cover to the machine with the 4
flange-head bolts (5/16 x 1 inch) that you removed in
step
3
of
Disconnecting the Battery (page
6. Install the finger-pull cover into the holes in the battery
cover.
8
Completing the Installation of
the Kit
No Parts Required
Procedure
1. Rotate the battery-disconnect switch to the On
position; refer to Operator's Manual for the machine.
2. Start the engine and check for exhaust leaks at the
turbocharger-exhaust pipe and the muffler.
Note: Repair all leaks before installing the side panel.
3. Install the right-side panel; refer to Operator's Manual
for the machine.
(Figure
2) with the lock-washer nut
6
of
Disconnecting
(Figure
2) with the lock-washer nut
5
of
Disconnecting
(Figure
1).
1).
11
Advertisement
