Table of Contents
Advertisement
Quick Links
ROPS Beacon Kit
Workman
Model No. 133-0609
This product contains a chemical or chemicals known to the State of California to
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Replace any decal that is damaged or lost.
1. Beacon
1. Beacon—10 A
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
MD or HD Series Utility Vehicle
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
120-0771
121-1702
Register at www.Toro.com.
WARNING
CALIFORNIA
Form No. 3404-252 Rev A
Installation Instructions
Original Instructions (EN)
All Rights Reserved *3404-252* A
Printed in the USA
Advertisement
Table of Contents
Related Manuals for Toro 133-0609
Summary of Contents for Toro 133-0609
- Page 1 Form No. 3404-252 Rev A ROPS Beacon Kit Workman ® MD or HD Series Utility Vehicle Model No. 133-0609 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Wire harness Route the wire harness. Cable tie Beacon bracket U-bolt Flange nut (3/8 inch) Install the beacon assembly.
- Page 3 For MD Utility Vehicles Route the wire harness as shown in Figure 1 and secure the wire harness to the machine with cable ties as necessary. Figure 1...
- Page 4 For HD Utility Vehicles Route the wire harness as shown in Figure 2 and secure the wire harness to the machine with cable ties as necessary. Figure 2...
- Page 5 Installing the Beacon Installing the Rocker Switch Assembly Parts needed for this procedure: Parts needed for this procedure: Rocker switch Beacon-light decal Beacon bracket U-bolt Procedure Flange nut (3/8 inch) Beacon socket 1. Remove the plastic plug from the left side of the dash (Figure Beacon assembly Procedure...
- Page 6 Figure 8 Figure 6 1. Wire-harness-terminal ring 2. Ground-block terminal 1. Rocker-switch blades 2. Female connector Connecting the Battery Connecting the Wire Harness to the Ground-Block Terminal No Parts Required and Installing the Fuse Procedure Parts needed for this procedure: Connect the negative battery cable;...
- Page 7 Notes:...
Need help?
Do you have a question about the 133-0609 and is the answer not in the manual?
Questions and answers