Advertisement
1. Positive-battery cable
2. Negative-battery cable
3. Ring terminal
6. Move back the insulator boot and remove the
lock-washer nut (3/8 inch) securing the positive-battery
cable to the positive stud of the battery and remove the
cable from the battery
Disconnecting the Battery-Disconnect
Switch
1. At the inboard side of the jump post, move back the
insulator boot, remove the nut, and remove the cable
form the threaded stud
1. Jump post
2. Right-cowl panel
3. Threaded stud
Figure 2
4. Lock-washer nut (3/8 inch)
5. Negative stud (battery)
6. Positive stud (battery)
(Figure
2).
(Figure
3).
Figure 3
4. Cable terminal
5. Insulator boot
6. Locknut
2. At the battery-disconnect switch, remove the screw that
secures the knob to the shaft of the switch
1. Right-cowl panel
2. Shaft (battery-disconnect
switch)
3. Lock washer
3. Remove the jam nut and lock washer that secure the
disconnect switch to the right-cowl panel
4. Push the shaft of the battery-disconnect switch
rearward to separate the switch from the cowl panel
(Figure
4).
2
(Figure
Figure 4
4. Jam nut
5. Knob
6. Screw
(Figure
4).
4).
Advertisement
