Design; Functions; Important Components - HADEF 260/23 Installation, Operating And Maintenance Instruction

NOTICE!
Use only in the intended atmosphere with a humidity of up to 100%, but not under water!
DANGER!
In particular, use is not permitted:
 for tearing loose fixed loads, dragging of loads as well as diagonal pulling
 for pulling against a fixed point without additional safety and/or measuring equipment against exceeding
the nominal load
 in potentially explosive atmospheres, unless the equipment has been modified for this purpose and
this is shown on special type plates it carries for this purpose.
in reactor containments

 for transporting persons
 for holding lifted loads
 for scenic use
 when persons are under suspended loads
4.2

Design

HADEF wire rope winches for stationary use are
fitted with holes for installation. The housing is
made of steel plate.
The winch can be installed in any position
desired, make sure, however, the wire rope exit is
correct.
For outside use we recommend to use a
protective roof.
4.2.1 Wire rope exit
Wire rope exit "A" 300 kg and 600 kg
4.3

Functions

The load is lifted/ lowered, by turning the winch handle. The incorporated load-pressure-brake prevents
automatic lowering of the load after release of the winch handle. Little after run of the load or turn of the
winch handle is due to the system and not a mistake.
4.4

Important components

 Housing
Made of steel plate
 Brake
Load pressure brake
 Gear
Spur gear
 Safety crank
Safety crank with load pressure brake and fold grip
 Drumdisengaging (optionally)
Mechanism For easier pulling out the uncharged wire rope.
5.52.246.00.01.02
Wire rope exit "B" 1000 kg up to 3000 kg
7