Table of Contents
Advertisement
Installation (cont'd)
Arm Adjustment(NON-HV)
STEP 1. Ensure case is level to the ground.Check level
as shown(pg 9).
STEP 2. Remove service section deck pans and arm drain/
pipe covers to avoid damaging parts during adjust
ment.
STEP 3. Remove fasteners from rear cover raceway
to gain access to adjument bolts.
*Note: Be careful to not damage/tug electrical outlets or
devices attached to the raceway cover.
STEP 4. Place level on the top of the upper arms as shown
to measure adjustments made to arms.
To properly adjust the height of the glass requires that all
hinge arms of each section be loosened before attempting
to change the arm position.
REMOVE CASE
DRAIN/PIPING COVERS
STEP 5. Locate and loosen lock bolts under each canopy
arm.
13
ARM
LOCK BOLT
BASE CHANNEL
NOT SHOWN
Advertisement
Table of Contents
