Table of Contents
Advertisement
Installation (cont'd)
STEP 4. Loosen lock bolt (See Detail B)
STEP 5. Properly adjust the height of the glass
requires that all hinge arms of each section be
tightened or loosened evenly.
•
Turning the bolt clockwise, the front arm and
glass will lower.
•
Turning the bolt counter-clockwise, the arm
and glass will raise.
STEP 6. Tighten lock bolt
STEP 7. Replace access cap and cover.
IMPORTANT! Preload the canopy arm to
minimize sag from product.
IMPORTANT! ATTEMPTING TO COMPEN-
SATE FOR POOR INSTALLATION PRACTIC-
ES BY MANIPULATING THE CANOPY HARD-
WARE WILL RESULT IN UNSATISFACTORY
WORKMANSHIP AND POSSIBLY CAUSE
HARDWARE FAILURE AND/OR INJURY.
After all the glass height has been adjusted, tighten all the
lock screws previously loosened.
Glass must be parallel to ledge when viewed from front.
Glass height should be centered on "V" glass seal as
demonstrated below
IMPORTANT: Attempting to compensate for poor
installation practices by manipulating the canopy
hardware will result in unsatisfactory workmanship
and possibly cause hardware failure and/or injury.
DETAIL B
(BASE CHANNEL NOT SHOWN)
ALIGN GLASS
WITH "V" SEAL
STEP 4
DETAIL A
STEP 3
12
Advertisement
Table of Contents
