Arm Adjustment - Hussmann SPECIALITY VR3/HV Series User Manual

Deli/bakery service merchandiser

Table of Contents

Installation (cont'd)

VR3HV Arm Adjustment

STEP 1. Ensure case is level to the ground.

Check level at the bulkhead.

STEP 2. Remove access cap and cover as shown

below

STEP 3. Loosen lock bolt (See Detail B)

STEP 4. Properly adjust the height of the glass

requires that all hinge arms of each section be

tightened or loosened evenly.

• Turning the bolt clockwise, the front arm and

glass will lower.

• Turning the bolt counter-clockwise, the arm

and glass will raise.

STEP 5. Tighten lock bolt

STEP 6. Replace access cap and cover.

IMPORTANT! Preload the canopy crm to

minimize sag from product.

REMOVE CAP

AND COVER

IMPORTANT! ATTEMPTING TO COMPEN-

SATE FOR POOR INSTALLATION PRACTIC-

ES BY MANIPULATING THE CANOPY HARD-

WARE WILL RESULT IN UNSATISFACTORY

WORKMANSHIP AND POSSIBLY CAUSE

HARDWARE FAILURE AND/OR INJURY.

STEP 4

DETAIL A

DETAIL B

(BASE CHANNEL NOT SHOWN)

STEP 3

Table of Contents