Emerson Rosemount 1410S Reference Manual page 60

Redundant Gateway systems
December 2023
Table B-1: Redundancy Diagnostics
Parameter
RF_COVERAGE_FAILURE
REDUNDANT_A_ONLINE
REDUNDANT_A_MASTER
REDUNDANT_A_PING
REDUNDANT_A_ETH0
REDUNDANT_B_ONLINE
REDUNDANT_B_MASTER
REDUNDANT_B_PING
REDUNDANT_B_ETH0
In addition to the redundancy diagnostics, an additional check may be configured to test
network connectivity to a host system or other application. The redundant system will use
this check to determine the best connectivity option and which Gateway should be set to
the active Gateway.
To configure network connectivity check:
1. Navigate to System Settings → Gateway → Ethernet Communication.
2. Enter the host system IP address in the Check Network Connectivity IP Address
3. Select Save Changes.
60
field.
(continued)
Description
Check to verify that both Gateways have the
same RF coverage of the wireless field network
Operational status of Gateway A
Indication if Gateway A is the active system
Indication if Gateway A is able to ping designated
host IP address
Electrical connection status of the primary
Ethernet port for Gateway A
Operational status of Gateway B
Indication if Gateway B is the active system
Indication if Gateway B is able to ping designated
host IP address
Electrical connection status of the primary
Ethernet port for Gateway A
Reference Manual
00809-0600-4410
Data type
8-bit unsigned
int
Boolean
8-bit unsigned
int
Emerson.com