BATEC MINI 2 User Manual Lines page 68

Disinfecting the HANDBIKE BATEC ELECTRIC
To disinfect the HANDBIKE BATEC ELECTRIC, follow the steps below:
- Use a hydro-alcoholic sanitiser and a cloth.
et the cloth ith a generous amount of sanitiser.
Rub the cloth over any surfaces that come in contact
bars, buttons, display panel and detaching lever.
- Leave to air dry.
IMPORTANT!
Sand and salt ater can damage some parts of the HANDBIKE BATEC ELECTRIC
after prolonged contact. Clean it after use in these conditions.
Cleaning front and rear wheels
Make sure the front heel and rear heels turn freely and eliminate any dirt.
Checking brakes
Make sure that hen you squeeze the brake levers, both have su cient contact
ith the disc for e ective braking.
Greasing cables and chains
Apply a drop of grease or light coat of Teflon spray to the cable connecting levers
and to chains, after removing the old grease. After applying, remove any excess
grease.
Greasing the transmission mechanism
Apply a drop of grease or light coat of Teflon spray to the transmission mecha-
nism, after removing the old grease. After applying, remove any excess grease.
Having HANDBIKE BATEC ELECTRIC serviced by an authorised distributor
The recommended preventive maintenance and any repairs to your BATEC ELEC-
TRIC HANDBIKE must be done by a company authorised by BATEC MOBILITY.
Replacing tyres and inner tubes
Before installing a ne inner tube, check the base of the rim and inside all of the
tyre to remove any foreign bodies and, if necessary, clean ell. Check the condi-
tions of the rim tape, particularly around the valve hole. Only strong, properly
placed rim tape can provide long term protection against damage to the inner
tube caused by burrs and sharp spoke heads.
– 29 –
ith the user: handle-