BATEC MINI 2 User Manual Lines page 59

• Free heel mode: To use the HANDBIKE BATEC ELECTRIC in free heel mode:
– S itch the device o
– To move for ards or back ards, use the rims on the heelchair to move the
HANDBIKE BATEC ELECTRIC and wheelchair in the desired direction.
– To turn, turn the HANDBIKE BATEC ELECTRIC with one hand while propelling
the wheelchair with the other.
– To stop, use the HANDBIKE BATEC ELECTRIC brakes or the rim on the heel-
chair.
• Lights: There is a button on the HANDBIKE BATEC ELECTRIC handlebar to switch
on the front and rear lights. When you push the button, the front light will go on
in normal mode and the light indicator on the display panel
hen you push the front light button again, it changes to high beam mode,
and so on. To turn o the lights, hold the button do n for 2 seconds. The front
light is below the battery and the two rear lights, on either side of the stand
frame. ( ee fig. 36a, 36b, 36c)
ANTI-SLIP SYSTEM
To activate the Anti-Slip System:
This is only possible if the HANDBIKE BATEC ELECTRIC is stopped and the throttle
not engaged (see Fig. 8).
• Press the Front gear button (8) for 3 seconds.
– The light indicator (1) (2) (3) on the display panel ill blink.
– The Anti Slip System is no active.
hen the Anti Slip System is active for 2 seconds, it stops the HANDBIKE BATEC
ELECTRIC from sliding back on a hill and keeps the
starting.
Deactivate the Anti-Slip System:
This is only possible if the HANDBIKE BATEC ELECTRIC is stopped and the throttle
not engaged.
– Press the Front gear button (8) for 3 seconds.
– The light indicator (1) (2) (3) on the display panel lights up.
The Anti Slip System is no longer active.
ith the Anti Slip System deactivated, the HANDBIKE BATEC ELECTRIC ill once
again behave as normal.
The Anti Slip System comes standard on the SCRAMBLER 2 model. For other
models, please check.
ith the key.
– 20 –
ill turn green.
heel from sliding hen