– Data of TRIP 1, AVG and RT can be reset at the same time hen one of the
three data functions is being reset.
– ODO, CLOCK and TT data cannot be reset.
3. Press M and R buttons simultaneously for 2 seconds to display the SETTING
SCREEN 1. ( ee fig. 53)
. Press M button to move bet een all functions in loop sequence from one
function screen to another as 12/2 hour, clock, circumference
ber and Km/h or MPH.
– Press R button to increment the flashing digit by 1 or convert units.
– Press M button to confirm the digit setting and jump to next digit or next
setting screen to be set.
– The c (circumference number) values are those:
HANDBIKE BATEC ELECTRIC Mini 2: 990
HANDBIKE BATEC ELECTRIC Electric 2: 1445
HANDBIKE BATEC ELECTRIC Scrambler 2: 1621
– Press M for 2 seconds at any setting screen to finish the setting and go to
INFORMATION SCREEN
. On SETTING SCREEN 1 (step ) pressing M and R buttons simultaneously for
2 seconds will display the SETTING SCREEN 2. ( ee fig. 54)
– Battery voltage value is on the bottom and manufacturer fine adjustment
battery value is on top.
6. To return to INFORMATION SCREEN and fix all settings press M button for 2
seconds, if the screen displays SETTING SCREEN 1 press M button for 2 seconds
again. ( ee fig. 55)
IMPORTANT!
• Do not change the battery voltage value and fine adjustment battery value.
• Don t exit SETTING SCREEN 1 by s itching o the battery.
• If the battery is fully charged and the screen display shows the following when
s itching on, you must follo steps 3,
6. MAINTENANCE AND REPAIRS
Your HANDBIKE BATEC ELECTRIC has been carefully designed for optimal perfor-
mance, but it is important that you carry out certain preventative maintenance
tasks in line with the use you give your HANDBIKE BATEC ELECTRIC. This will
greatly reduce the chance of problems and increase the lifespan of your HAND-
BIKE BATEC ELECTRIC.
and 6. ( ee fig. 56)
– 27 –
heel num-
Need help?
Do you have a question about the MINI 2 and is the answer not in the manual?