Connection To The Mains - Proline VH3000CCM Manual

Connection to the mains

This appliance can only to be connected to a network 230 V~ 50/60 Hz.
Connect always the earth wire.
Respect the connection diagram.
The connection box is located underneath at the back of the hob casing. To open the cover use
a medium screwdriver. Place it in the 2 slits situated in front of the 2 arrows.
Monophase 230V~1P+N
Attach the earth to the terminal "earth", the neutral N to terminal N, the Phase L1 to one of the
terminals L1.
Mains
230V~ 50/60Hz
* calculated with the simultaneous factor following the standard EN 60 335-2-6
Tightening the screws too much can damage the screw thread. It is therefore advisable
to keep screwing and unscrewing to a minimum. Ensure that the cables are correctly
inserted and tightly screwed down. 4 weeks after installation, check and retighten
terminal screws.
We cannot be held responsible for any incident resulting from incorrect connection or
which could arise from the use of an appliance which has not been earthed or has been
Connection Cable diameter
1 Phase + N 3 x 1,5 mm²
equipped with a faulty earth connection.
Cable
H 05 VV - F
H 05 RR - F
32
Protection calibre
16 A *