Crestron Green Light GLPS-HDSW-FT Design Manual page 38

GLXX-2DIM8
The GLXX-2DIM8 is a Crestron Green Light Express dimming module
which features 8 channels of incandescent, magnetic low-voltage, and 2-
and 3-wire fluorescent dimming. The module is part of a complete
Crestron engineered GLPX Green Light Express dimming or switching
panel.
> 8 channels of incandescent, MLV, 2-wire fluorescent dimming
> 4 channels of 3-wire fluorescent dimming
> Phase-synchronous detection eliminates lamp flicker
> Selectable non-dim mode
> Supports 100 to 277 Volt applications
> 16 Amp load rating per channel
> Short circuit and overload protection
> Positive air gap at each output
> Phase-independent channels
> Cresnet communications
> Redundant power capability—module powered via line or Cresnet
> Local controls for testing and verification
> Local and remote override capability
> Non-volatile power failure memory
Load Ratings
Switch Channels
Per Channel
Dim Load Types
Switch Load Types
Power Requirements
Primary
Secondary (optional)
Environmental
Temperature
Humidity
Heat Dissipation
Electrical Regulatory Certifications
UL508, Section 41 (Endurance Test) and Section 61C (Electronic Ballasts)
UL924, Emergency Power Equipment
IEC60669-2-1, Section 19.102 (Contact mechanisms incorporated in electronic switches, intended for fluorescent lamp circuits or
other capacitive loads)
SCCR Rating - 65kA
CE
Crestron Commercial Lighting Design Guide
8
16 Amps at 100-277 Volts AC, 50/60 Hz
Incandescent, Magnetic Low-Voltage, Neon/Cold Cathode, 2- wire Fluorescent Ballast, or 3-wire
Fluorescent Ballast (uses adjacent channel for 3rd wire, i.e. channels 1 & 2 are to be used for one 3-
wire load)
Incandescent, Magnetic Low-Voltage, Electronic Low-Voltage, Neon/Cold Cathode, Fluorescent
Ballast, High-Intensity Discharge
100-277 Volts AC, 50/60Hz, supplied via channel 1 (L1, N1)
5 watts at 24 Volts DC, supplied via Cresnet®
32° to 104°F (0° to 40°C)
10% to 90% RH (non-condensing)
154 BTU/Hr
34