Personal Protective Equipment; Residual Risks - Trox Technik X-CUBE X2 compact 2 Transport And Installation Manual

2.3 Personal protective equipment

Description of personal protective equipment
Hearing protection
Hearing protection protects against hearing damage
resulting from noise exposure.
Industrial safety helmet
Industrial safety helmets protect the head from falling
objects, suspended loads, and the effects of striking the
head against stationary objects.
Protective clothing
Protective clothing is close-fitting, with low tear resist-
ance, close-fitting sleeves, and no projecting parts.
Protective gloves
Protective gloves protect hands from friction, abrasions,
punctures, deep cuts, and direct contact with hot sur-
faces.
Safety harness
A safety harness protects people from a fall when they
are working at height. You are at risk from a fall if the
task is at height and if there is no railing in place.
When you put on a safety harness, connect it via an
energy-absorbing lanyard to a suitable anchor point.
Safety harnesses must only be used by individuals who
have been specifically trained to use them.
Safety shoes
Safety shoes protect the feet against crushing, falling
parts, and from slipping on slippery ground.

2.3.1 Residual risks

Suspended loads
Danger of death due to suspended loads!
Falling loads may cause serious injury or death.
Therefore:
–
–
–
–
–
–
–
–
–
Industrial trucks
Danger to life from industrial trucks!
Objects and other loads could fall in an uncontrolled
manner from industrial trucks during transport and
cause serious injuries or even death. There is also
the risk that people will not be seen and could thus
be run over by the vehicle driver.
–
–
–
–
Air handling unit X-CUBE X2 compact 2
Personal protective equipment > Residual risks
DANGER!
Never walk under suspended loads.
Only move loads under supervision.
Observe the specifications for the intended
lashing points.
Do not attach the lifting gear to protruding
machine parts or lugs on attached components
Ensure that the lifting gear is secure.
Only use approved hoisting devices and lifting
gear with with sufficient load-bearing capacity.
Do not use any frayed or worn ropes and belts.
Do not place ropes or belts near sharp edges or
corners; do not knot or twist.
Place the load on the ground before leaving the
workplace.
WARNING!
Industrial trucks may only be operated by trained
vehicle drivers (e.g. forklift drivers).
People should only pass industrial trucks when
the vehicle driver has signalled that they have
seen them.
Only approved industrial trucks with sufficient
load-bearing capacity may be used.
Materials should never be transported in the
vicinity of people or the zones occupied by
people.
Safety
9