Bowflex TreadClimber TC10 Owner's Manual page 38

,, s
Unitwill not powerup/turnon/start
Speed displayed is notaccurate
Walking belt misahgnment
Speed dependent grindingor
scrapingnoise
Hesitation or beltslippingwhen
walkingon unit
Knocking noises whenunit is
operating
Outbt
Power c ordnot plugged in
Power s witchturnedoff
Safetykeynotplugged in
Displaysetto wrongunit
of measure. ( English/
Metric)
Rearbeltguides
Beltalignment
Rollers or motor
Walking belttension
Igusbushing
Hydraulic cylinderbolts
Makesureoutlet is functioningcorrectly. V erify
this byplugginganotherdevice (ex:lamp)into
the outleLif outletis connected to a light switch,
checkto makesureit is on.if outletis notfunc-
tioningfind a working outleL
Makesurethe powercordis firmlysecured to A/C
inleton the unit andfirmlyinsertedintoa non-
GFI w all sockeL
Makesurethe powerswitchat the rearof the unit
is in the "ON"position.Switchwill light up redto
indicatepower i s present.
Hug SafetyKeyintoConsole (See Safety Key (Emer-
gency S top Procedures) within Features section).
Change displayunits.
Beltsshouldrideontop oftriangularblackbelt
guidesat rearoftreadles_
Beltsare notrequired to beperfectly centered
and aretypicallyfartherout in the rearthan
they arein the fronLThismayvarydepending
on user'sstride,if belt istrackingto oneside
far enough to causerubbingof belt,consultthe
"AdjustingtheWalkingBelts"procedure.
Check walkingbeltalignmenLBeltcontactwith
metalguidesunderTreadle canmakea loud
grindingsound, i f beltsaremisaligned, a djust
walkingbell
Contact C ustomer C arefor furtherassistance.
Adjustwalkingbelttensionbyfollowingthe
"AdjustingtheWalkingBelt" procedure.
if knockingsoundseems to becomingdirectly
fromthe rearroller,checkIgus(yellow "hat"
shaped)bushings and replace if cracke&
Check andtighten bothupperand lowerbolts
that connectthe hydraulic cylinders to the uniL
88