The Console Night Light - Kenmore SENS-A-CLEAN 665.75842 Use & Care Manual

THE CONSOLE NIGHT LIGHT
The console night light is located on the top of the
control panel. It has two replaceable parts. The
fluorescent light is a standard FST5 miniature
fluorescent lamp. The starter is the knob-shaped
part to the left of the light. It is a standard FS-5C
starte_ The console night light will not work during
the Self-Cleaning cycle.
Toinstall t hestarterand/orbulb:
1.
Fit starter prongs into starter mounting base and
turn clockwise.
Toturnthe lightonandoff:
• Press the TOP pad momentarily.
d'J_)
Toremove thestarterand/orbulb:
1. Unplug range or disconnect power.
2. Push down with thumbs on front of lens, while
pulling up with fingers on back of lens.
2. Slide bulb prongs into bulb mounting base
ends. Roll the bulb forward or backward 90 °
until you hear a click.
3. Push down on the left bulb mounting base. You
will hear a click indicating the assembly has
latched.
3. Push release lever toward the bulb. The left end
of the light assembly will raise up.
Release Bulb
Lever
4.
Replace the lens cover. Position the two rear lens
cover tabs in front of the two metal spring clips,
located directly behind the bulb. Push back and
down on the lens to lock lens into position.
4.
To remove the starter, turn it counterclockwise
and lift out of its mounting base.
!
i
45