Oven Light; Console Night Light - Kenmore 66572133300 Use & Care Manual

• Solution of 1/2cup (125 mL) ammonia to 1 gal. (3.75 L) water:
Soak for 20 minutes, then scrub with scouring or steel-wool
pad.
• Oven cleaner:
Follow product label instructions.
Porcelain enamel only, not chrome
• Dishwasher
WARMING DRAWER (on some models)
Make sure drawer is cool.
• Mild detergent
STORAGE DRAWER (on some models)
Make sure drawer is cool and empty before cleaning.
For more information, see "Storage Drawer" section.
• Mild detergent
Drawer Liner (on some models)
Remove all stored items from drawer and lift out drawer liner.
• Clean with mild detergent.
Oven Light
The oven light is a standard 40-watt appliance bulb. It will come
on when the oven door is open. It will not work during the Self-
Cleaning cycle. When the oven door is closed, press the OVEN
pad to turn on and off.
Before replacing, make sure the oven and cooktop are cool and
the control knobs are off.
To Replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb countemlockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
To Remove Starter and/or Bulb:
1. Unplug range or disconnect power.
2. Push down with thumbs on the front of the lens cover while
pulling up with fingers on the back of the lens cover.
3. Push release lever toward bulb. The left end of the light
assembly will raise up.
1 2 3
1. Starter
2, Release Lever
3. Bulb
4. TO remove starter, turn it counterclockwise and lift out of its
mounting base.
5. To remove bulb, roll it forward or backward 90 ° until it clicks,
then lift out.
To Install Starter and/or Bulb:
1. Fit starter prongs into starter mounting base and turn
clockwise.
2. Slide bulb prongs into bulb mounting base ends. Roll the bulb
forward or backward 90 ° until it clicks.
The console night light is located at the top of the Electronic
Oven Control panel. It has two replaceable parts. The fluorescent
light bulb is a standard F8T5 miniature fluorescent lamp. The
starter is the knob-shaped part to the left of the light bulb. It is a
standard FS-5C starter. The console night light will not work
during the self-cleaning cycle.
To turn on and off: Press the TOP pad.
3. Push down on the left end of the bulb mounting base. When
the assembly latches, it will click.
23