4.
CONFIGURATION
4.1.
CONFIGURATION STEPS
Perform the following steps to configure the 7700PTX-MVP:
1. Connect a PC running a console application to the PTX debug/monitor port via the adapter
cable.
2. Configure the 7700PTX-MVP's network parameters.
3. Configure the parameters of each serial port to match those of the OVE.
4. Configure what protocols will be received on what ports (incoming protocol translation setup).
5. When transmitting data via TCP, configure the IP address and TCP port of the peers (outgoing
protocol translation setup).
6. Configure the incoming port-to-outgoing port routes.
7. Power off the 7700PTX-MVP.
8. Physically wire the serial port(s) of the 7700PTX-MVP to the OVE.
9. Power on the 7700PTX-MVP.
4.2.
DEBUG/MONITOR PORT CONNECTION
The 7700PTX-MVP is configured via the debug/monitor port, the header of which is labelled J1. A
special Evertz adapter cable allows this port to connect to the COM port of a personal computer. The
following steps describe this procedure.
1. Locate the small, keyed, four–pin end of the upgrade cable provided by Evertz.
2. Connect it to the four-pin interface (J1) near the front of the 7700PTX, directly above the card
unlock latch.
7700PTX-MVP Unidirectional UMD Protocol Translator
Figure 4-1: Upgrade Jumper
Revision 1.9
7700 MultiFrame Manual
7700PTX-MVP - 5