Main Menu; Network Configuration; Table 4-1: 7700Ptx-Mvp Main Menu - evertz 7700 Manual

9. Enter the information as listed in Figure 4-3.
10. Press the <Enter> key or select OK.
HyperTerminal window open.
11. Apply power if the 7700PTX-MVP does not have power. The boot sequence and Main Menu
are displayed in the HyperTerminal window.
12. If the 7700PTX-MVP has power, press the <Enter> key to view the 7700PTX-MVP's menu
system.
13. Various 7700PTX-MVP parameters are configurable via the 7700PTX-MVP's menu system, the
root of which is called Main Menu.
4.3.

MAIN MENU

Table 4-1 lists the entries available in the 7700PTX-MVP's Main Menu.
Entry Item
1

Network Configuration

2 Serial Port Setup
Protocol Translation
3
Setup
4 Engineering/Debug
4.4. NETWORK CONFIGURATION
1. From the Main Menu select Network Configuration.
2. If DHCP (Dynamic Host Configuration Protocol) is desired, then the Use DHCP field is set to
True. Otherwise, the IP address, subnet mask, and gateway (if any) are set and the Use DHCP
field is set to False.
3. Once the network settings are configured, the user can save the settings by selecting Save and
Exit before exiting the Network Configuration, otherwise the user can select Exit to exit without
saving.
The 7700PTX-MVP must be rebooted for any network setting changes to take
effect.
7700PTX-MVP Unidirectional UMD Protocol Translator
The "COM Properties" window closes, leaving the
Notes
IP address, subnet mask, gateway, etc.
Baud rate, number of data bits, etc. of serial ports that connect to OVE (for
incoming serial data) or MVP output cards (for outgoing serial data).
Incoming, Outgoing, and Route configuration.
Used for troubleshooting.

Table 4-1: 7700PTX-MVP Main Menu

Revision 1.9
7700 MultiFrame Manual
7700PTX-MVP - 7