Ethernet; Figure 5-2: Outgoing Communication - evertz 7700 Manual

7700 MultiFrame Manual
7700PTX-MVP Unidirectional UMD Protocol Translator
If Out Cmds is reported as 0 when you expect a non-zero value:
•
Confirm that at least one route points to the serial port in question
•
Recall that any route changes require a reboot of the 7700PTX-MVP

5.2.2. Ethernet

Once the outgoing protocol translation has been configured to point to a peer and the route
configuration for a given port has been set to point to an outgoing Ethernet Sub-Port, one can check if
data is being transmitted over that Sub-Port using the following method:
1. From the Main Menu select Engineering/Debug.
2. Select Show task statistics.
3. Look for the table where the ports are listed as E1. Each entry in this table corresponds to an
outgoing Ethernet Sub-Port.
correspond to 192.168.18.40 and 9800 respectively.
4. The column Tx Passed lists, in hexadecimal, the number of commands the 7700PTX-MVP has
transmitted to that peer.
192.168.18.40/9800.
7700PTX-MVP - 24

Figure 5-2: Outgoing Communication

Figure 5-2 shows a peer whose IP address and TCP port
Figure 5-2 indicates that four packets have been sent to
Revision 1.9