Degritter MARK II User Manual page 33

INSTALL SOFTWARE
1. Turn off Degritter from the
switch at the back and wait 10
seconds so that the capacitors
in the machine can discharge.
2. Insert the SD card into the
machine in the slot at the back
as shown on the image. When
inserting the card, the bare
contact pins on the card must
face the direction where the
water tank is.
NOTE
If the machine's display stays black
and the unit will not start, then there
is either a problem with the file on
the SD card, the SD card file format,
or with the SD card connection.
3. Turn on the machine from
the switch on the back. After
turning on the machine, the
screen will remain blank for a
few seconds. During this time
the machine will upgrade
itself. It will take a few seconds
to start its display and once
it does it will display an icon
for SD card removal. You can
remove the card from the
machine.
4. Navigate to the INFO menu of
the machine and check the
software version. It must be the
same as the version that was
displayed on our website from
where you downloaded it from.
VERIFY SOFTWARE VERSION
Once the machine has started,
navigate to the INFO section in
the menu and verify that the new
version listed is the same as on the
degritter.com webpage.
Serial: 3000f00
Version: 3.0.11
Version
Runs: 285
Temp: 24C
33