Microswitch; Axis Controller - Champion 100515 Installation Manual

HOME STANDBY GENERATOR- ALL aXis CONTROLLER
22-kW (MODEL 100304)
This generator has ON/OFF switches that when turned off, will
shut down the HSB (if running) and deactivate the aXis controller
preventing future starts. These switches should be used in
instances where the HSB needs to stay off regardless of utility
power presence. When either switch is in the OFF position, the
HSB will not exercise or start for any reason.
When both of the switches are in the ON position, the aXis
controller will be energized and the HSB will be controlled by the
programming of the aXis controller. Both switches need to be in
the ON position in order for the HSB to operate in AUTO mode.
N OTE: Both switches need to be in the ON position to place the
aXis Controller in the AUTO mode and in order to exercise
the HSB.
Inside
ON
OFF

Microswitch

There is a microswitch located behind aXis Controller panel. This
microswitch prevents accidental starting while accessing this
area.
MODELS
®
To access this microswitch, remove four M6 x 12 bolts from the
cover using a 10mm wrench (not included).
Swing the aXis Controller panel forward after removing the top
cover, HSB starting will be disabled.
Close and secure the aXis Controller panel, then the top cover with
Back
four M6 x 12 bolts using a 10mm wrench (not included) to start
the generator. Once closed, the microswitch will allow the HSB to
start.
ON

aXis Controller

aXis CONTROLLER STATUS ICONS
The status icons are located at the top of the aXis Controller.
OFF
Utility Pole
The utility pole icon will indicate utility is present and the source
of power.
37
INSTALLATION
®