Dacor DOB30M977D Series User Manual page 81

CAUTION
After replacing the door, make sure to reconnect the wires. Push them inward to arrange
them as they were before you removed the door. Wires that are not connected or
arranged correctly can be caught in the door or damaged by heat.
4. Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5. Locate the oven door hinge locks in
the corners of the oven door, and
rotate the hinge locks toward the oven
chamber to the locked position. See
Step 3 (illustration A) in the "Removing
the oven doors" section for the proper
locked position.
6. Close the oven door.
7. When the hinges are properly installed
and the door is closed, there should be
an even gap between the door and the
control panel. If one side of the oven
door is hanging lower than the other,
the hinge on that side is not properly
installed.
8. Reconnect the LED light's wire harness
and re-insert the rubber.
English 81