Related Manuals for Dacor DOB30M977DM
Summary of Contents for Dacor DOB30M977DM
- Page 1 Installation Instructions Modernist Built-In Electric Wall Oven DOB30M977 Part No. 112174 Rev C...
-
Page 2: Table Of Contents
Contents Before you begin... Important Customer-service info If You Need Help... Important safety instructions Related equipment safety Transport Installation requirements Location requirements Installation materials Single ovens—Product Dimensions Double ovens—Product Dimensions Installation instructions Preparing to install the oven Removing and replacing the oven door(s) Electrical connection Installing the oven Installation checklist... -
Page 3: Before You Begin
Dacor Customer Assurance (800) 793-0093 x2813 (USA, Canada) Mon – Fri, 5:00 a.m. to 5:00 p.m. Pacific Time Website: www.dacor.com/customer-care/contact-us All specifications are subject to change without notice. Dacor assumes no liability for suchchanges. © 2017 Dacor. All rights reserved. English 3... -
Page 4: Important Safety Instructions
Important safety instructions Related equipment safety Remove all tape and packaging before using the oven, and dispose of the packaging. Never let children play with packaging material. Do not modify the oven (e.g., do not remove panels, wire covers, or screws). Transport To avoid damaging the oven vent, use the transport method shown at left. - Page 5 Important safety instructions WARNING • Follow the information in this manual precisely to avoid fire or electrical shock that may cause property damage, personal injury, or death. • Ensure the oven is properly installed and grounded by a qualified technician. •...
-
Page 6: Installation Requirements
Installation requirements Location requirements Observe all governing ordinances IMPORTANT: Specified cutout dimensions are minimums and must be used. • The cabinet recess must completely enclose all but the face of the oven. • A grounded electrical supply is required. (See Electrical Requirements.) •... -
Page 7: Installation Materials
Installation Materials Provided items 6 screws (M4 L16) Install Handle (only for double oven) (4 needed for installation, 2 extra) Needed Items Junction Box Wire Nuts Drill ” Conduit Connector Phillips Screwdriver English 7... -
Page 8: Single Ovens-Product Dimensions
Installation requirements Single ovens—Product Dimensions ⁄ ” (33 mm) ⁄ ” (89 mm) ⁄ ” ⁄ ” (731 mm) (691 mm) ⁄ ” ⁄ ” (587 mm) (757 mm) Front Side ⁄ ” (1200 mm) Conduit length ” (724 mm) English... - Page 9 Standard cabinet dimensions • Dimensions are minimums (except electrical supply location E) • Allow at least 22” between the open oven door and opposing cabinetry, walls, etc. • Leave at least 1” clearance under oven and 1-3/8 in. from cutout opening to cabinet above or countertop.
- Page 10 Installation requirements Flush-cabinet dimensions • Dimensions are minimums (except electrical supply location E) • Allow at least 22” between the open oven door and opposing cabinetry, walls, etc. • Leave at least 1” clearance under oven and 1-3/8 in. from cutout opening to cabinet above or countertop.
-
Page 11: Double Ovens-Product Dimensions
Double ovens—Product dimensions ⁄ ” (33 mm) ⁄ ” 50” (1307 mm) (1267 mm) ⁄ ” (757 mm) ⁄ ” ⁄ ” (587 mm) (89 mm) Front Side 67” (1700 mm) Conduit length ” (724 mm) English 11... - Page 12 Standard cabinet dimensions • Dimensions are minimums (except electrical supply location E) • Allow at least 22” between the open oven door and opposing cabinetry, walls, etc. • Leave at least 1” clearance under oven and 1-3/8 in. from cutout opening to cabinet above or countertop.
- Page 13 Installation requirements Flush-cabinet dimensions • Dimensions are minimums (except electrical supply location E) • Allow at least 22” between the open oven door and opposing cabinetry, walls, etc. • Leave at least 1” clearance under oven and 1-3/8 in. from cutout opening to cabinet above or countertop.
- Page 14 If codes permit and a separate ground wire is used, a qualified electrician should verify that the ground path and wire gauge comply with local codes. Check with a qualified electrician if you are unsure of the oven's grounding status. This oven must connect to a grounded-metal, permanent wiring system.
-
Page 15: Installation Instructions
Installation instructions Preparing to install the oven WARNING Excessive Weight Hazard To avoid personal injury and property damage, use two or more people to move the oven. 1. Decide the oven's final location. Avoid drilling/cutting household wiring/plumbing. 2. To avoid floor damage, set the oven on a cardboard sheet. (Do not lift by the door handle or any part of the front frame.) 3. - Page 16 Carefully pull out the wire to reveal the connector. Uncouple the connector. Removing the oven door(s) Open the oven door fully flat. Find the door hinge locks in both Unlocked corners of the door, and flip them Locked down to the unlocked position (see left) so the door can be removed.
- Page 17 Installation instructions Replacing the oven door(s) CAUTION If needed, get help lifting the door into the hinge slots. Do not lift the door by the handle. 1. Grasping each side at the midpoint, lift the door, and face the oven. 2.
-
Page 18: Electrical Connection
Electrical connection WARNING Electrical Shock Hazard • Disconnect power before servicing. • Use 8-gauge solid copper wire. • Ground the oven. • Failure to follow these instructions can result in fire, electrical shock, or death. This oven is manufactured with a neutral (white) power-supply wire and a cabinet- connected ground (green or bare) wire twisted together. - Page 19 Installation instructions 4-Wire Cable from Home Power Supply IMPORTANT: Use the 4-wire cable from home power supply in: • the US where local codes do not allow grounding through neutral • New Branch circuit installations (1996 NEC) • mobile homes and recreational vehicles •...
- Page 20 3-Wire Cable from Home Power Supply - U.S. Only IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. NOTE: Connect all wires with UL-listed wire connectors (H). Connect the 2 black wires (C). Connect the 2 white wires (D) and the oven's green (bare) ground wire.
-
Page 21: Installing The Oven
Installing the oven 1. Using 2 or more people, lift the oven partially into the cabinet cutout. Hang the install handle on the side of the oven. (See left.) NOTE Before the next step, remove the install Install handle; keep it for future use. Handle Push against the oven's front frame until the back of the frame contacts... -
Page 22: Installation Checklist
6. If there is an error, one of these codes appears on the display with an alert sound. DOB30M977** Model Error code Remark Upper Broil Double/Single Oven Upper Bake Feature Lower Broil Double Oven Only Lower Bake 7. Should an error occur, contact Dacor Customer Assurance: (800) 793-0093 x2813. English... - Page 23 Notes English...
- Page 24 DG68-00923A-00 Dacor ∙ 14425 Clark Avenue, City of Industry, CA 91745 ∙ Phone: (800) 793-0093 ∙ Fax: (626) 403-3130 ∙ www.dacor.com...