Table of Contents
Advertisement
14. The Console (23) can use two AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the Console or other electronic components.
Remove the battery cover from the back of the
Console (23), and insert batteries into the bat-
tery compartment (D). Make sure to orient the
batteries as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
15. While a second person holds the Console (23)
near the Upright (2), connect the wires on the
Console to the Upright Wire (31) and the Pulse
Wires (A).
Insert the excess wire into the Console (23) or
into the Upright (2).
Tip: Avoid pinching the wires. Attach the
Console (23) to the Upright (2) with four
M4 x 12mm Screws (66).
See step 5. Tighten the M8 x 20mm Screws (54)
and the M8 Locknuts (53).
16. Orient the Seat Carriage (61) and the Seat Post
(24) as shown.
Slide the Seat Carriage (61) into the Seat Post
(24). Then, tighten the Seat Knob (48) and an
M8 Washer (55) into the Seat Post and the Seat
Carriage.
14
23
15
23
16
24
55
48
14
D
Avoid pinching
the wires
31
2
A
66
61
Advertisement
Table of Contents
