Table of Contents
Advertisement
10. Finger tighten an M8 x 20mm Hex Screw (57)
with an M8 Split Washer (63), an M8 Large
Washer (72), and an M8 Plastic Washer (27) into
the right end of the Upright Axle (26).
Then, tighten both M8 x 20mm Hex Screws (57)
at the same time.
Next, identify the two 8mm Dome Caps (83),
the four 17mm Dome Caps (not shown), and
the two 19mm Dome Caps (not shown).
Press an 8mm Dome Cap (83) firmly onto each
M8 Large Washer (72).
11. Identify the Right Pedal (12) and the right Pedal
Arm (11). Orient the Right Pedal and the right
Pedal Arm as shown.
Attach the Right Pedal (12) to the right Pedal
Arm (11) with two M10 x 45mm Bolts (91), two
M10 Washers (92), and two M10 Locknuts (93);
start both Bolts, and then tighten them.
Attach the Left Pedal (13) to the left Pedal
Arm (11) in the same way.
10
83
57
72
11
13
12
27
72
63
57
26
83
11
91
12
11
92
93
Advertisement
Table of Contents
