ICON WESLO MOMENTUM G 3.2 User Manual page 11

8. Finger tighten an M8 x 20mm Hex Screw (57)
with an M8 Split Washer (63), an M8 Large
Washer (72), and an M8 Plastic Washer (27) into
one end of the Upright Axle (26).
Using a plastic bag to keep your hands clean,
apply a generous amount of the included
grease to the Upright Axle (26) and to two Wave
Washers (73).
Next, orient the Left Upper Body Arm (5)
assembly as shown. Make sure that the
wide side (C) of the tube is in the indicated
location.
Insert the Upright Axle (26) through the Left
Upper Body Arm (5) from the direction shown.
Then, slide a Wave Washer (73) onto the Upright
Axle (26).
9. Tip: Avoid pinching the Upright Wire (31).
Gently pull upward on the Upright Wire, and then
insert the Upright Axle (26) through the left side
of the Upright (2) as shown.
Next, slide a Wave Washer (73) onto the Upright
Axle (26).
Orient the Right Upper Body Arm (6) assembly
as shown. Make sure that the wide side (C) of
the tube is in the indicated location.
Slide the Right Upper Body Arm (6) onto the
right side of the Upright Axle (26).
8
57
63
72
27
9
5
11
26
5
C
73
Grease
31
2
26
73
6
C
Avoid
pinching
the Upright
Wire (31)