Huawei EchoLife HG8110 Service Manual page 162

EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual
Issue 02 (2011-12-08)
Product
HG8240
HG8245
HG8247
HG8447
huawei(config)#ont-srvprofile gpon profile-id 10
huawei(config-gpon-srvprofile-10)#ont-port eth 4 pots 2 catv 1
After the configurations are complete, run the commit command to make the
configured parameters take effect.
huawei(config-gpon-srvprofile-10)#commit
huawei(config-gpon-srvprofile-10)#quit
d. (Optional) Configure an alarm profile.
– The ID of the default GPON alarm profile is 1. The thresholds of all the alarm
parameters in the default alarm profile are 0, which indicates that no alarm is
reported.
– In this example, the default alarm profile is used, and therefore the
configuration of the alarm profile is not required.
– Run the gpon alarm-profile add command to configure an alarm profile,
which is used for monitoring the performance of an activated ONT line.
5. Add an ONT on the OLT.
The ONT is connected to the GPON port of the OLT through optical fibers. The service
can be configured only after an ONT is successfully added on the OLT.
Two ONTs are connected to GPON port 0/1/1. The ONT IDs are 1 and 2, the SNs are
6877687714852900 and 6877687714852901, the management mode is OMCI, and
ONT line profile 10 and service profile 10 are bound to the two ONTs.
a. Add an ONT offline.
If the password or SN of an ONT is obtained, you can run the ont add command
to add the ONT offline.
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#ont add 1 1 sn-auth 6877687714852900 omci
ont-lineprofile-id 10 ont-srvprofile-id 10
huawei(config-if-gpon-0/1)#ont add 1 2 sn-auth 6877687714852901 omci
ont-lineprofile-id 10 ont-srvprofile-id 10
b. Automatically find an ONT.
If the password or SN of an ONT is unknown, run the port portid ont-auto-
find command in the GPON mode to enable the ONT auto-find function of the
GPON port. Then, run the ont confirm command to confirm the ONT.
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#port 1 ont-auto-find enable
huawei(config-if-gpon-0/1)#display ont autofind 1
//After this command is executed, the information about all ONTs
connected to
the GPON port through the optical splitter is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Number of Number of
ETH Ports POTS Ports
4 2
4 2
4 2
4 4
3 Configuration
Number of
CATV Ports
-
-
1
1
154