Safety Information Before using the device, read these precautions carefully. Follow these precautions and instructions to ensure optimal product performance and to avoid danger and legal or regulatory violations. Fire-proof Precautions Keep the device away from fire or heat sources, including electric heaters, ovens, stoves, and ...
2 POTS ports HG8242 series 1 CATV port 4 Ethernet ports HG8040 series 4 Ethernet ports HG8240 series 2 POTS ports NOTE If some device types are not in the preceding list, refer to http://www.huawei.com.
Weight Maximum System Power GPON Terminal (Including the Power Consumption Adapter) HG8010 series About 270 g 3.6 W HG8110 series About 300 g 5.5 W HG8012 series About 350 g HG8120 series About 350 g 5.5 W HG8242 series About 400 g...
Page 5
Mounting a GPON Terminal On The Desk The schematic diagram for placing the device on a desk horizontally is as follows (The HG8240H5 is used as an example here.): Mounting a GPON Terminal Onto The Wall Step 1 Mark the positions of two holes used for mounting a GPON terminal, ensure that the two holes have the same spacing as the two mounting holes.
NOTE This terminal is mainly placed horizontally on a desk. When it is mounted onto a wall, the silkscreen of its indicator is reversed. If you have a special requirement on the silkscreen, purchase another terminal. Connecting Cables This document uses the HG8240H5 as an example to describe the connections. Ports on GPON terminals of other types may be different.
Page 7
Use an optical fiber to connect the optical port on the ONT and the Step 1 optical port on the wall. • The optical port of the HG8242 series, HG8240 series and HG8040 series are at the back of the device. For how to connect the optical port, see the following figure (The HG8240H5 is used as an example here.):...
Page 8
NOTE 1.The optical connector connected to the OPTICAL port is an SC/APC connector, and the type of the optical connector connected to the optical port in the wall is determined by practical conditions. 2.To ensure normal use of fibers, make sure that the fiber bend radius is larger than 30 mm.
Indicator Description Table 1 Indicator status description 1 Indicator Status Description The CATV function is enabled and CATV signals Steady on are received. CATV The CATV function is disabled or CATV signals are not received. The ONT is registered with the softswitch but no Steady on service flows are transmitted.
Disposal and recycling information The crossed-out wheeled-bin symbol on your product, literature or packaging reminds you that all electronic products must be taken to separate waste collection points at the end of their working lives; they must not be disposed of in the normal waste stream with household garbage.
Page 11
FAQs The LOS indicator blinks. If the LOS indicator blinks once two seconds, check whether the pigtail fiber is properly connected and the connector is clean. If the GPON terminal blinks twice a second, contact the service provider for help. The PON indicator is off.
Warranty Card Thank you for choosing Huawei Technologies Co., Ltd. To get better services, please read this warranty card carefully, fill in the required information, and preserve this card in good condition. User Information Personal or company's full name:__________________________________________________ Address/Postal Code:_________________________________________________...
In any case that is not covered by this limited warranty or should the warranty expire, Huawei shall charge for the service(s) claimed for the products if the product is still remediable. Huawei reserves all rights to interpret this limited warranty.
Page 14
Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other trademarks and trade names mentioned in this document are the property of their respective holders.