Troubleshooting guide
The display has
poor contrast
or shows no
information.
The wireless
sensors are not
sending any data
to the main unit.
The display
shows "—.-".
The display
shows "LL.L"
or "HH.H".
The temperature
or precipitation
shown is
incorrect.
Replace the batteries in the main unit.
• If the main unit receives no signals from a sensor
for 3 minutes, an automatic scan is started. After
the main unit has scanned for 1 hour without
finding a sensor, —.- is displayed.
• Remove the batteries from the sensor, wait for a
while and then reinsert them.
• Put new batteries in the sensor. Only use
high-quality alkaline batteries.
• Try scanning for the sensor manually:
Hold [ CH ] for 3 seconds. Note that any saved
maximum/minimum values will be deleted.
• Check the distance between the sensor and the
main unit. The distance should be between 1.5
and 30 m.
• Make sure that nearby metal structures etc. do not
interfere with the radio signal.
• Move the main unit away from other electronic
devices such as routers, computers and TV sets.
The sensor is outside the measuring range.
• Remove the batteries, wait for a while and then
reinsert them. Begin a new scan for the sensor
(Hold in [ CH ] for 3 seconds).
• Make sure that the units are free from interference
from heat sources, air conditioning units or the
equivalent.
12