Raider RD-AG70 User Manual page 20

20 www.raider.bg
flange firmly to the shaft at the end of the thread. Tighten cupped disk or wire brush with a spanner.
WARNING: Prior to assembly and adjustment always pull out the power plug from the mains socket.
Adjusting the wheel guard
WARNING:TO PREVENT SERIOUS INJURY:Do not used the tool without the wheel guard properly
installed
1,loosen the wheel guard bolt
2,rotate the wheel guard as you needed shield during your planned work.
3,tighten the wheel guard bolt securely
4,check the wheel guard it is firmly in place,adjust if neccery before proceeding.
Intalling the side handle
WARNING:TO PREVENT SERIOUS INJURY:Do not used the tool with one handle only or without
side handle properly installed
1,the side handle may be installed on either side of gearcase.
2,screw the threaded end of the side handle into the selected position.tighten securely before working.
Fixing grinding disc
Pull out the power plug.
Depress and hold down the spindle lock (2) to tighten the spindle. Turn the shaft until it was locked.
Remove the outer flange (c) and tighten the flange using the special wrench (d) provided.
Fit the desired disc (e) on the inner flange and replace the outer flange and tighten the flange. Release
the spindle lock.
WARNING: only use wheels with maximum safe operating speed rated at or above the RPM listed
on the "WARNING"selection of the tool`s nameplate.This speed is based on the strength of the
wheel,allowing for a reasonable measure of safety,It is not meat to imply a best or most efficient
operating speed ,Do not exceed the Maximum Safe Operating Speed.
16. Dust-extraction system.
Dust released during the processing of materials such as paints containing lead, some wood,
minerals and metals can be hazardous to health. By skin contact or inhalation of such powders can
cause allergic reactions and / or respiratory illnesses to working with power tools or nearby persons.
Certain powders, for example released during the processing of beech and oak are considered to be
carcinogenic, particularly in combination with chemical treatment of wood (chromate, preservatives,
etc.).. Where possible, use dust-extraction system. Provide good ventilation in the workplace. Use of