TP-Link Omada DS1018GMP Installation Manual page 2

Unmanaged rackmountable switch

Hide thumbs Also See for Omada DS1018GMP:

Table of Contents

About this Installation Guide

This Installation Guide describes the hardware characteristics, installation methods and the

points that should be attended to during installation. This Installation Guide is structured as

follows:

Chapter 1 Introduction

This chapter describes the external components of the switch.

Chapter 2 Installation

This chapter illustrates how to install the switch.

Chapter 3 Connection

This chapter illustrates how to do the physical connection of the switch.

Appendix A Troubleshooting

Appendix B Hardware Specifications

Audience

This Installation Guide is for:

Network Engineer

Conventions

• When using this guide, notice that features available in TP-Link | Omada series products may vary

by model and software version. Availability of TP-Link | Omada series products may also vary

by region or ISP. All images, steps, and descriptions in this guide are only examples and may not

reflect your actual experience. Some models featured in this guide may be unavailable in your

country or region. For local sales information, visit https://www.tp-link.com.

• The speed of the ports in Extend Mode will downgrade to 10 Mbps. The actual transmissio

distance may vary due to power consumption of PoE-powered devices or the cable quality and

type.

• PoE budget calculations are based on laboratory testing. Actual PoE power budget is not

guaranteed and will vary as a result of client limitations and environmental factors.

• This guide uses the specific formats to highlight special messages. The following table lists the

notice icons that are used throughout this guide.

Remind to be careful. A caution indicates a potential which may result in device damage.

Remind to take notice. The note contains the helpful information for a better use of the

product.