Suzuki Jimny 2022 Manual page 408

INSPECTION AND MAINTENANCE
Oil Filter Replacement
(2)
(1)
(3)
80T090040
(1) Loosen (counterclockwise)
(2) Tighten (clockwise)
1) Using an oil filter wrench, turn the oil fil-
ter (3) counterclockwise and remove it.
2) Using a clean rag, wipe off the mount-
ing surface on the engine where the
new filter will be seated.
3) Smear a small amount of engine oil
around the rubber gasket of the new oil
filter.
4) Screw the new filter by hand until the fil-
ter gasket contacts the mounting sur-
face.
9-29
Tightening (viewed from filter top)
(4)
80T090050
(4) Oil filter
(5) 3/4 turn
NOTICE
To tighten the oil filter properly, it is
important to accurately identify the
position at which the filter gasket
first contacts the mounting surface.
5) Turn the oil filter clockwise as specified
below from the point of contact with the
mounting surface (or to the specified
(5)
torque) using an oil filter wrench.
Tightening torque for oil filter:
3/4 turn or
14 Nm (1.4 kg-m, 10.3 lb-ft)
NOTICE
To prevent oil leakage, check that the
oil filter is tight, but do not over-
tighten it.
Refilling with Oil and Oil Leakage
Check
1) Pour oil through the filler hole and
install the filler cap.
For the approximate capacity of the oil,
refer to "Recommended fuel / lubricants
and capacities (approx.)" in "SPECIFI-
CATIONS" section.
2) Start the engine and carefully check the
oil filter and the drain plug for leakage.
Run the engine at various speeds for at
least 5 minutes.
3) Stop the engine and wait about 5 min-
utes. Check the oil level again and add
oil if necessary. Check for leakage
again.
80TS - 01E