Suzuki Jimny 2022 Manual page 461

NOTICE
Carefully lower the spare wheel to the
ground.
5) Loosen the wheel nuts, but do not
remove them.
6) Jack up the vehicle (refer to the "Jack-
ing Instructions" in this section).
WARNING
• Shift into "P" (Park) for an automatic
transmission, or into "R" (Reverse)
for a manual transmission vehicle
when you jack up the vehicle.
• Never jack up the vehicle with the
transmission in "N" (Neutral). Oth-
erwise, unstable jack may cause an
accident.
CAUTION
Immediately after the vehicle has
been driven, the wheels, the wheel
nuts and the area around the brakes
might be extremely hot. Touching
these areas may cause burn injury
Do not touch these areas, immedi-
ately after the vehicle has been
driven.
7) Remove the wheel nuts and wheel.
(6)
(9)
(10)
(7)
(8)
(9)
(8)
80T100090
8) Before installing the new wheel, clean
any mud or dirt off from the surface of
the wheel (6), hub (7), thread part (8),
surface of the wheel nuts (9) and sur-
face of the wheel holes (10) with a
clean cloth. Clean the hub carefully; it
may be hot from driving.
9) Install the new wheel and replace the
wheel nuts. Tighten each nut snugly by
hand until the wheel is securely seated
on the hub.
EMERGENCY SERVICE
1
4
3
2
5
80T100010
Tightening torque for wheel nut:
100 Nm (10.0 kg-m, 72.3 lb-ft)
10)Lower the jack and fully tighten the nuts
in a crisscross fashion with a wrench as
shown in the illustration.
WARNING
Use genuine wheel nuts and tighten
them to the specified torque as soon
as possible after changing wheels.
Incorrect wheel nuts or improperly
tightened wheel nuts may come
loose or fall off, which can result in
an accident. If you do not have a
torque wrench, have the wheel nut
torque checked by an authorized
SUZUKI dealer or a qualified work-
shop.
80TS - 01E
10-8