CARDS
INFORMATION TO KNOW BEFORE YOU BEGIN
•
Make sure an adequate earth ground connection has been made be-
tween the grounding screw on the back of the controller and an
appropriate grounding point in your site.
•
Adequate earth ground connection is mandatory to avoid any damage
or injuries.
•
Wear an ESD wrist strap, ensuring that it makes good contact with bare
skin.
•
Attach the ESD wrist strap end to an earth ground (grounding screw
on the back of the controller or unpainted bare metal spot of a grounded
equipment rack).
•
Turn off the power switch of the controller.
•
Turn off the power sources used to power the controller at the circuit
breaker.
Note: Redundant Power Supply units do not have a power switch.
•
Disconnect all cables (except the earth ground connection) from the
controller
CAUTION: Power source cables must be disconnected last.
Installation
21